| ||||||||||||||||||
| ||||||||||||||||||
 | | | | | ||||||||||||||
| ||||||||
| | | ||||||
THE LARGEST LOWER COST COMPRESSION MOLD MANUFACTURER IN NORTH AMERICA | |||||||||||||||||||
 |  | ||||||||||||||||||
Plant 1 72,000 square feet modern plant located in Fenton, Michigan. Complete tool tryout capability with three (3) hydraulic presses. |  | ||||||||||||||||||
 | |||||||||||||||||||
Plant 2 18,000 square foot modern plant located in Fenton, Michigan. 60 ton cranes 3000 & 1500 ton hydraulic presses. | |||||||||||||||||||
Plant 3 35,000 square foot plant located in Taylor, Michigan. Our wholly owned sub-supplier to Plants 1 & 2 | |||||||||||||||||||
| |||||||||||||||||||
Our facility is equipped with the latest state-of-the-art equipment. We have the capability to handle blocks up to 60 tons and machine block sizes up to 100" wide by 300" long. We are completely self-sufficient, with the ability to construct solid models and develop cutter paths as needed right at the machine. Our try-out facility offers press capacity up to 3000 tons with a maximum plate size of 144" x 144"; steam, oil, water, and electric heat capabilities; supported by experienced personnel. | |||||||||||||||||||
 | |||||||||||||||||||
 | |||||||||||||||||||
| | | | | | | | | | | | | | | | | | | |
 | ||||
|  | | ||
| ||||
| | | | |